Connector for lived the electrical communication cables Of duraseal it was intended for connecting the veins of electrical communication cables by the diameter 0,8 - 2,3 mm.
Standard container contains 100 pieces.



Characteristics
Temperature range from - 50°[S] to +125°[S].

Steadfast to the action: gasoline, antifreeze, dis. fuel-, motor oil, 5% salt solution.

Insulation resistance: 1000[MOm] with 100[V].

Dielectric strength - 2500[V] of alternating current.

Maximum voltage drop with the current 16 A of 2[mV] (for sectioning the conductor of 1 [mm]2).



Application
The cases Of duraseal adapt for the sealed joint of installation wires and cores of the control and signal cables



Construction
On the case or the tip for the connection by pressing is located the heat-shrinkable tubing with the thermo-fusible glue beyond the internal surface.

For pressing of cases or tips are used the tongs Of raychem AD 1522- T



Installation
The necessary size of case is selected. The isolation against the length of 7,5 mm. is moved away based on the ends of the veins.

At room temperature the ends of the current-conducting veins are put beside the case (without the special difficulties, since at this temperature glue it is in initial state).

Installation must be carried out by the appropriate pressing tool and the source of heating. One should use a tool Of raychem AD 1522 for the pressing and a thermo-foehn for heating and sitting of shell.

The adhesion, installed with the aid of the connectors Of duraseal, is recommended to shut for the sake of the heat-shrinkable tubing, for example, OF MWTM, XCSM or BLX of the production of company [Raykhem].